Separate names with a comma.
You know the right values for the 12dB/octave at 6000 Hz For the 18dB/octave C1 = 5.6 microfarad and C2 should be 16 microfarad The coil L1 =...
I made a mistake, the first cap C1, needs to be 5.6-microfarad. The other values are right.
I just thought of something. Why not go for a 18dB per Octave filter. The slope is getting steep so your crossover point can be as low as 5000Hz....
Math is your friend Azn, start building, you've got it all figured out. One 4.7 microfarad cap and one 0.15mH coil. Your calculations are...
I have no experience with the Rockford Sixty, so I don't know. Your four speaker wires from your factory radio will go to the input side of the...
The Clean Sweep has no adjustments. It will adjust itself using the calibration CD that it comes with. You will cut all four sets of speaker wires...
I just posted there, go check it out.
Perfect, your thinking and your thinking is right. Because of the steeper slope, you can go to a lower frequency safely. For a 12dB/octave (one...
Hey AZN http://www.caraudiotalk.com/audio-forum/car-stereo-speakers/5259-i-make-mistakes.html please read post #9 I remember all
You got it :lol: I just wanna add one thing, this putting one rear speaker out-of-phase will not always work. The rear speakers needs to be...
If you wanna retain the OnStar you will need a PAC OS-1. This will allow the use of an aftermarket radio with your OnStar. You can also add amps...
Its really not that difficult, Bikini Calculus can help you. Not only is it fun to watch, it very accurate. I said it was hard to understand...
If you insist on getting the factory unit repaired call United Radio. I have used them a bunch of times. Excellent Company, I've never had a...
Found it, thank you
Not the same thing, not even close. By using the fader we would not only reduce level, directionality would still be there. By wiring the...
I hate iTunes but it is a necessary evil. Every now and then I try something and I totally crash one of my ipods. Like trying to convince a GenII...
And I'm still not sure why that might work. I'll need to look it over later today. The only real problem I have with it is the 3 microfarad cap....
Yes I did. Thanks
First you need an etching solution (Radio Shack) and a single sided copper clad board (any electronics parts wholesaler) Radio Shack only has...
The completed crossover, now I will take it to work and hook it up to my test bench Monday. [IMG] Again this is something that anyone can...
