Separate names with a comma.
Your math is correct, but looking at the math suggests that might be for your low pass? If so no resistor on the low pass. If its for your...
It is OK to swap depth and height. My parts list cut outs will no longer be right. Do not adjust the box dimensions, the braces do not take up...
There is NO divider board in my parts list, so they will share the same airspace Now just in case you wanna downfire, the dimensions will be...
Box designer???? I just use a calculator I am assuming that we are using 3/4-inch MDF so here we go. The Box should be 28-inches wide by...
Then go with a box around 2 cu ft box. And thats for both woofers, 1 cu ft each. I would have them share the same enclosure, no divider. Also, can...
Wait, are we talking about a ported box or a sealed box. If you want accurate bass then sealed, if you want extended bass response and loud then...
OK here are the recommendations from your owners manual [ATTACH] [ATTACH] Middle is typically the best compromise. But with sealed boxes,...
I'm not sure I would have explained it that way, but it works so OK
Or you could learn to do it yourself. But seriously this Vtrek Conccept XT 124 12" sub woofer is not telling me anything about the woofer. How...
Both posts have been deleted
Its always best to run both woofers in the same enclosure. I knew I should not have posted property e, but what it means is that the woofer doesnt...
Downfire enclosures work very well, especially if you want to recover some of that low frequency you lost due to a too small enclosure. The woofer...
I think we are missing something here. First, two speakers in the same air space should be treated as one speaker. The following properties...
The bigger end is for an XM/ Sirius antenna, so it has had an external add on XM unit. The smaller plug in more than likely the power plug.
I don't see why not. If they can share the airspace there will be some improvement in sound. Just make sure the PVC is atleast 4-inches or more
Most prefab boxes are of a really poor quality. But remember you get what you pay for. ProBox for example is a little pricey, but worth every...
OK, I'm not sure why you needed the GMOS LAN 02. Unless you just wanted to keep the OnStar. But it still simplifies the aftermarket radio install....
I always did that with prefab boxes. I would drill a 4 or 6-inch hole in the divider so that the lower bass frequecies would improve. And it...
Its almost that simple, but remember that the tweeters resistance (called impedence because it changes with frequency) changes. As frequency goes...
OK I'm finally on Christmas break, and I looked at your crossover. Here is the problem, your down 12dB at 2500Hz on both the HP and the LP parts....
