Separate names with a comma.
Thanks Pedro for the reply.I'm also wondering if there is a way to change the port tuning on a custom made box.There is one for sale locally on...
My trunk started leaking and my box got wet and moldy.It got really wet,wet enough to make the wood bow out over 1".So now I have found the leak...
How do I find out what the impedence rise is?
I have my subs and port both facing the back so when you open the trunk they are facing you.My box is about 6" away from the trunk latch.My car is...
I have retuned my sub box down to 34hz.I have 3 10" rf old school subs(rfp-1210) that are dual4's rated at 400 watts rms each.The box is 3.08 cuft...
It depends on how power hungry the amp is.I had a 900 watt rms@2ohms amp(hifonics bxi1208d)that drew way more power than my 1000wrms@2ohm alpine...
I think the review's that I read were in fact correct.These have alot of jean shaking midbass and the tweets are detailed to say the least.They...
That would be good for hifonics.I really liked my amp,but it did draw alot of power.My lights dimmed really bad with that amp,and now only a...
It should work just fine.I personally don't care for the sound of square subs,but hey to each his own.
I had the bxi1208d and it tested out at a rms of 765 or something like that at 2ohms.Rated at 900 rms at 2ohms.If I remember right my voltage was...
It sounds like the time when I didn't pull fuse from amp before switching amps.I touched the power wire from one to the speaker out of another...
Well,you really can't have 2 dvc 4ohm subs wired to 2ohm load.It's either a 1ohm or 4ohm load:...
You should be fine as long as you turn your gain all the way down,don't use the bass boost at all,and set your gain on your amp with the volume up...
Cool,good luck.I hope it stays together.
I would do the big three wiring upgrade.That amp will draw alot of power,so make sure you use the proper gauge wire for the amp and big three.
That's a '68-'72.What year is it?Does it have a 302 or 390?What are your plans with it?
They might have some old stock from the rf days.I also noticed that.
I hope this helps: http://www.reaudio.com/speaker_box/LPort_Box_Calc.html
I would assume that your speakers are hitting your grills.1/8 isn't enough clearance.
Thanks for the advice.The box is glued and screwed together,so I figured I will cut the face off(from the sub side),make the port changes,and then...
