/ Register

My new Build!!

Discussion in 'Subwoofer Box and Custom Fabrication' started by danracer, Dec 30, 2007.

Page 2 of 3
  1. aznboi3644

    aznboi3644 Full Member

    if you wanted them to solder a little better you need to crimp then SLIGHTLY so there isn't a big gap between the wire and the terminal...kinda get it snug
     
    aznboi3644, Jan 4, 2008
    #21
  2. danracer

    danracer Full Member

    yeah i wanted to crimp them but didnt find the hammer lol
     
    danracer, Jan 4, 2008
    #22
  3. aznboi3644

    aznboi3644 Full Member

    could have used the vice grips you used to hold the wire lol...better control than a hammer
     
    aznboi3644, Jan 4, 2008
    #23
  4. danracer

    danracer Full Member

    well i bought a new sub today :D a new audiopipe txx-15aprd ill post picks now :D
     
    danracer, Jan 5, 2008
    #24
  5. danracer

    danracer Full Member

    [​IMG]
    [​IMG]
    [​IMG]
     
    danracer, Jan 5, 2008
    #25
  6. aznboi3644

    aznboi3644 Full Member

    those are decent bang for the buck subs
     
    aznboi3644, Jan 5, 2008
    #26
  7. danracer

    danracer Full Member

    well im done its sounds Loud!!! and its on a sealed prefab "dog House" tightly sealed ohh and its wired at 2 ohms so im giving it like 1k wrms
     
    danracer, Jan 5, 2008
    #27
  8. pedro quiroga

    pedro quiroga Well-Known Member

    you got a vid?
     
    pedro quiroga, Jan 5, 2008
    #28
  9. danracer

    danracer Full Member

    [​IMG]

    cellphone vid ftl
     
    danracer, Jan 5, 2008
    #29
  10. pedro quiroga

    pedro quiroga Well-Known Member

    nice.i tryed that with my 10 and i could not even get any movement.
     
    pedro quiroga, Jan 5, 2008
    #30
  11. danracer

    danracer Full Member

    lol i was happy it did it since i have a minivan and never could do it lol
     
    danracer, Jan 5, 2008
    #31
  12. aznboi3644

    aznboi3644 Full Member

    is that with thet txx??
     
    aznboi3644, Jan 5, 2008
    #32
  13. danracer

    danracer Full Member

    yup it is w/ the new txx
     
    danracer, Jan 6, 2008
    #33
  14. danracer

    danracer Full Member

    [​IMG]
     
    danracer, Jan 6, 2008
    #34
  15. danracer

    danracer Full Member

    yesterday I went to a local comp and i did a 135.9 on a sealed cheapass prefab lol w/ the txx, im a bit dissapointed with the score but the box sucks lol and i was using an ipod to meter so i wasnt getting a lot of input voltage into the amp...the amp does GREAT on music it is a lot louder than my last setup but not good on the meter because of the damn box lol, i also tryed 4 coustic 12s and did a 138.sumthing lol to test the amp at 1 ohm and it was LOUD it was even hard for me to breath in there during the pass but w/e ill do a box and hopefully get my score up :D, I also did bassrace 120-129.9 and i won yay and i took a stetsom 4 channel amp ^_^ so it wasnt a bad night after all.
     
    danracer, Jan 13, 2008
    #35
  16. pedro quiroga

    pedro quiroga Well-Known Member

    sweet deal.pics of the amp?
     
    pedro quiroga, Jan 13, 2008
    #36
  17. danracer

    danracer Full Member

    [​IMG]
    [​IMG]
    [​IMG]
     
    danracer, Jan 13, 2008
    #37
  18. pedro quiroga

    pedro quiroga Well-Known Member

    sweet!nice amp.what are the spec's?
     
    pedro quiroga, Jan 13, 2008
    #38
  19. danracer

    danracer Full Member

    Channels - 4 Potency PMPO 1500W
    RMS Power @ - 13.8V
    STEREO 4 Ohms - 4 x 65W
    STEREO 2 Ohms - 4 x 100W
    BRIDGE 4 Ohms - 2 x 200W
    Consumption - 0,6 to 56A
    Input Tension - 13,8V
    Frequency Response - 15Hz to 50KHz
    Signal to Noise - > 90 dB
    Input Sensitivity - 0,2 to 6V
    Total Harmonic Distortion - < 0,2%
    Input Impedance - 50 K Ohms
    Output Impedance STEREO - 2 Ohms
    Output Impedance BRIDGE - 4 Ohms
    Damping Factor - > 400
    Lo Pass - 40 to 700Hz - Hi Pass - 70 to 700Hz
     
    danracer, Jan 13, 2008
    #39
  20. electrolytic

    electrolytic Full Member

    Nice going...See, the hard work does pay off lol, you got a free amp already! That sundown amp looks pretty serious looks like it could do 140-150db with the proper sub or subs and box. Post that circuitboard picture again lol. Looks sweet.
     
    electrolytic, Jan 13, 2008
    #40
Page 2 of 3