I'm Pissed

Discussion in 'Off Topic Discussion' started by hobbes26, Apr 5, 2004.

  1. hobbes26

    hobbes26 Full Member

    I got me a 'new' car this weekend, a '97 acura EL (basically a civic) and it's got
    cupholders waay in front of the shifter, deep under the console where there's also
    a little pocket to hold stuff. How am I supposed to get a regular sized cup in
    there? The console comes down so low, there's no room! What a waste.
     
  2. Civic96

    Civic96 Full Member

    Hammer time!
     
  3. Honest Bob

    Honest Bob Full Member

    I guess its like in my car. A soda can will fit, but it blocks my head unit from unfolding/folding. Plus if I step on the brakes to hard I imagine the soda would splash right into the head unit. Probably not a good idea :eek:
     
  4. hobbes26

    hobbes26 Full Member

    lol... it's minor... but u kinda wonder why they even bothered to put it
    where they did if there's no room to fit a cup in there


    "Hammer Time"???
    you mean, cut it out? can't - that's where i'm going to put my alpine
    HU...
     
  5. geolemon

    geolemon Full Member

    I thought the 1.6EL was a Canadian Accord?
    It's just a little Civic?

    On my Civic, the cupholder is cool in front of the shifter...
    You press the top, the lid flips open, and a spring-loaded cupholder pops out!

    My wife's VW beetle has 4 cupholders...
    Three of them under the dash just as you describe, that's about all you can fit is a soda can.
    And the fourth one is on the rear of the center console, for rear seat passengers... at least one of them. :lol:
     
  6. hobbes26

    hobbes26 Full Member

    Yup, it's a Civic... akin to the EX model in the US... slightly different
    though I think...

    I don't know if I can fit a soda can in there... maybe if you drink half
    first, then maybe you can tilt it enough to slide in there.

    My friend's RSX has 5 cupholders.... there's only 4 seats...
     
  7. KhaoticLE

    KhaoticLE Full Member

    saw and duct tape.... :p or you could fiberglass or bondo to make your own custom cup holder :D
     
  8. hobbes26

    hobbes26 Full Member

    There's just no room - I've left the stock CD player in there and put my
    deck in the slot above the cupholders.... can't cut it out now - then there
    wouldn't be any place to put the deck
     
  9. delvryboy

    delvryboy Full Member

    because it's a 1997 model

    right about that time, the manufacturers were going thru the "how many cupholders can we fit" phase :p

    GM was the worst, they had 7+ cupholders in all of their vehicles

    i did like the drivers side slide-out dash holder in the pickups, very convienent