Separate names with a comma.
That's an interesting problem. You should probably buy a cheap digital multimeter for about $10, and check the voltages when the car is off and...
They look like typical SMD transistors, and I think the 2G code means that they are BC850C - Check out the table on page 2:...
[IMG] You can see how the lower ports connect to the furthest chambers, and the upper ports are shorter, providing adequate port clearance from...
I was wondering how to calculate what the minimum relative cross sectional area any part of an enclosure can be, before the sound is affected...
It can be done, It depends how thick this speaker wire is. You might as well make the most out of this speaker wire, and use both leads/twist...
I haven't used that amp, but there are some good reviews of it around. It seems it will easily handle two of your speakers, but if you connect...
Fair enough. The cap will increase the load on the pc psu, as I explained above, which might just mean that perhaps you'd need a 500w psu instead...
I'd be surprised if you can run two powersupplies in parrallel without problems. It would be like running two alternators in parrallel. In either...
Thanks guys :D
I found the theile small parameters in the manual from the company website here on page 12:...
I agree. Again I haven't tried using big caps with a car system, but i'd expect the cap to put a larger yet more constant current draw on the...
I haven't tried this, but what about instead of adding a battery near the amplifiers, adding 1 or 2 farads of capacitance near the amps instead?...
Hi everyone I've been doing a fair bit of searching, and I think that the correct way to measure port length, is along the red line: [img]...
What I like about the Kicker CVR15" in bandpass, is that it can get a similar spl as vented, but it can go a little more deep, instead of dropping...
I've been playing with the Kicker S15L72 Connerray, and I can't get a nice response out of it in bandpass, unless I make the box huge, like...
I tried simulating the L5 and L7 in a bandpass Connerray2010, but they needed around ~150w more than the CVR subs for the same SPL iirc, as they...
Yep, i'm planning on porting both the front and rear chambers :D The driver parameters I used are in the first .wdr file I linked, and some of...
Hi everyone I've made a fair few sealed and vented boxes over the years for a variety of speaker sizes, but haven't made a bandpass box yet....