Sandt Dual Brahma Set up Discussion

[Honest Bob]

Dual Brahma 12"

Planning on chaining the trunk lid down?

[sandt38]

Originally posted by Honest Bob@Aug 4 2003, 07:24 PM
Dual Brahma 12"

Planning on chaining the trunk lid down?

Hehehe... Actually, I am going to fire them into the cabin, use plexi backs to show the motors, and seal the trunk off from the cabin... Almost a sealed IB setup if you will :P . Trunk flex should not be an issue, but door hinge failure may

[BlkX]

Haha, yea, if you went ported with dual b12's i'd be convinced you were outta your damn mind. That sounds like a pretty sweet setup man. Those DEI amps are pretty nice, i was really impressed with the DEI 600D i ran on the IDQ's.

Let it be known now that i will not set foot in that car once you get dual b12's in it.

[sandt38]

Originally posted by BlkX@Aug 4 2003, 08:57 PM
Haha, yea, if you went ported with dual b12's i'd be convinced you were outta your damn mind. That sounds like a pretty sweet setup man. Those DEI amps are pretty nice, i was really impressed with the DEI 600D i ran on the IDQ's.

Let it be known now that i will not set foot in that car once you get dual b12's in it.

Nada... Dual sealed Brahmas. Still not going to sit in the Nat?

[Honest Bob]

Ack, had me scared that I was going crazy for a moment Mike

Shouldnt have gone off topic. Sorry it wont happen again.


Anyways. Wont you be needing to upgrade your electrical system again Sandt? I would also like to see how you handle dressing up the back with the rear seat gone. I've wanted to put my sub facing in towards the cabin for a while but didnt want it to look like ****. Cutting up the factory bracing scares me too...

[flawlesskid]

I wont go near that sumbitch once you get dual b12's! As a matter of fact, i might not continue being your friend. We'll see though. Its gonna be stupid loud though. I'm tryin to find your point in getting them Mr. SQ Man.


Sitting in your car with dual B-12's would be like this----->

[BlkX]

Originally posted by sandt38+Aug 4 2003, 09:22 PM--></div><table border='0' align='center' width='95%' cellpadding='3' cellspacing='1'><tr><td>QUOTE (sandt38 @ Aug 4 2003, 09:22 PM)</td></tr><tr><td id='QUOTE'> <!--QuoteBegin-BlkX@Aug 4 2003, 08:57 PM
Haha, yea, if you went ported with dual b12's i'd be convinced you were outta your damn mind. That sounds like a pretty sweet setup man. Those DEI amps are pretty nice, i was really impressed with the DEI 600D i ran on the IDQ's.

Let it be known now that i will not set foot in that car once you get dual b12's in it.

Nada... Dual sealed Brahmas. Still not going to sit in the Nat? [/b][/quote]
Nope, i value what hearing i do have left .

[systempimp_1500]

You're gonna seal them?

If I had those, I'd go all out and port em...........






Jeff

[sandt38]

Originally posted by systempimp_1500@Aug 5 2003, 07:03 PM
You're gonna seal them?

If I had those, I'd go all out and port em...........






Jeff

Eh... 1 ported is mad loud. I like the Brahma ported, don't get me wrong, but I am a sealed guy at heart. I just like the output, and reactions I get, from the single ported. But now, it is all about me. I want the same power overall, and twice the woofer. Go big sealed, for extension, and perfect transients. With the 2 in there it will be killer loud to boot... I think if I ran 2 ported I may be looking for a good body man to remove the new bulges in the body panels

[Honest Bob]

Originally posted by sandt38@Aug 5 2003, 07:19 PM
I think if I ran 2 ported I may be looking for a good body man to remove the new bulges in the body panels

I think a woman would do a better job at removing new buldges :P